Same Day Service! Call Today!

(360) 292-1890

Serving the Puget Sound

Plumbing Services

 
Emergency Plumbing
Water Heaters
Sewer Lines
Drain Cleaning
Well Pumps
 

Contact Us

Angie's List

SIGNS THAT YOUR WELL PUMP IS GOING BAD

When your home depends on a private well for water, it is up to you to resolve any problems that arise with the system. If you're having trouble with your water system, look for signs that your submersible well pump is going out. Also check for anything else that might be causing the trouble. If you can't be sure, it is time to call in a professional.

No Water

  • One of the first and most obvious signs that there is a problem with your well system is when you turn on a faucet and no water comes out. This can be a sign of trouble with the submersible pump, since if the pump is not working there is no way for water to get out of the well. However, a lack of water can also point to something as simple as a blown fuse in the pump house, a broken pipe or a clogged line. Check for the easiest and most obvious problems that could cause you to have no water before you suspect the submersible pump. A clogged pump will stop pumping, but in this case, you may be able to clean it out rather than replace it.

    Poor Pressure

    If you turn on a faucet and have some water but the pressure is not good, it could be that your submersible pump is going bad. A pump that is not running at full capacity may cause problems with the water pressure due to insufficient water being pumped. Before pulling the pump out of the well, though, check for other problems that can cause the same symptom. One common culprit in this case is a bad pressure tank. This piece of equipment is located in the well house and uses an air-filled bladder to keep the water pressure constant. If it is not working properly, pressure will drop. Look for leaks in the pressure tank or small leaks in your water pipes. If everything above ground is fine, then the problem is most likely the submersible pump.

    Running Constantly

    A pump that runs constantly is most likely starting to encounter serious problems and may go out soon. When a submersible pump does not stop running, it may have a bad shutoff switch or a bad sensor, or the pump may be struggling to get enough water to the surface. The pump may also start and stop frequently, cycling on and off even when water is not needed. Frequent cycling can be a symptom of a minor problem, such as a waterlogged tank, but if it is not fixed, it will quickly destroy the pump.

    So if you have questions or concerns regarding your well pump, give Yelm Plumbing and Pumps a call and lets us put your mind at rest.

Yelm Plumbing and Pumps
Located at
7225 Pacific Ave. SE
Olympia, WA 98503
Phone: (360) 292-1890
Website:

Privacy Policy   |   Site Map